Display layout
Run mode (default screen)
The figure shows all possible symbols and characters that can be
shown on the display:
Item Icon Description
A Temperature reading using a - or + sign, two digital
characters, a decimal point and a character showing
either 0 or 5
B Alarm symbol
C Temperature unit
Change setpoint
The figure shows all possible symbols and characters that can be
shown on the display:
Item Icon Description
A Change setpoint mode
B Temperature setpoint, using a - or + sign, two digital
characters, a decimal point and a character showing
either 0 or 5
C Temperature unit
D Heating demand
Cooling demand
E Comfort mode
ECO mode
Alarms
The figure shows all possible symbols and characters that can be
shown on the display:
Item Icon Description
A Alarm mode
B Faulty indoor temperature sensor
Faulty floor temperature sensor
Faulty remote temperature sensor
Faulty outdoor temperature sensor
C Low battery indicator
D Relative humidity limit reached (high limit)
This symbol is only shown if cooling is active, and if
RH control is be activated in the Uponor Smatrix
PULSE app (requires communication module).
E Communication fault indicator
Uponor Smatrix Wave PULSE
|
Installation and operation manual
|
85