Vacon NX series - Page 188

Table 80: Fieldbus parameters
Index Parameter Min Max Unit Default Cust ID Description
P2.9.10
Fieldbus process
data out 8 selec-
tion
0 10000 37 859
Make the selection
of the Process
Data Out with the
parameter ID.
NXP drives only (In NXS, default values are not editable)
P2.9.11
Fieldbus process
data in 1 selection
0 10000 1140 876
The raw value of
process data in a
32-bit signed for-
mat. Choose con-
trolled data with
parameter ID Def:
FB Torque Refer-
ence.
P2.9.12
Fieldbus process
data in 2 selection
0 10000 46 877
The raw value of
process data in a
32-bit signed for-
mat. Choose con-
trolled data with
parameter ID Def:
FB Limit Scaling.
P2.9.13
Fieldbus process
data in 3 selection
0 10000 47 878
The raw value of
process data in a
32-bit signed for-
mat. Choose con-
trolled data with
parameter ID Def:
FB Adjust Refer-
ence.
P2.9.14
Fieldbus process
data in 4 selection
0 10000 48 879
The raw value of
process data in a
32-bit signed for-
mat. Choose con-
trolled data with
parameter ID Def:
FB Analogue Out-
put.
P2.9.15
Fieldbus process
data in 5 selection
0 10000 0 880
The raw value of
process data in a
32-bit signed for-
mat. Choose con-
trolled data with
parameter ID.
P2.9.16
Fieldbus process
data in 6 selection
0 10000 0 881
The raw value of
process data in a
32-bit signed for-
mat. Choose con-
trolled data with
parameter ID.
VACON · 188 MULTI-PURPOSE CONTROL APPLICATION
6
TEL. +358 (0)201 2121 · FAX +358 (0)201 212 205