Vacon NX series - Main Contactor

3.3 CONTROL SIGNAL LOGIC IN LOCAL/REMOTE APPLICATION
DIN3
≥ 1
DIN6
DIN2
DIN3
AI1
AI2
DIN1
DIN2
DIN3
DIN4
DIN5
A
B
A
B
A
B
Internal reverse
Internal fault reset
Fault reset input (programmable)
3.3 Keypad direction
Internal Start/Stop
Reference from fieldbus
Start/Stop from fieldbus
Direction from fieldbus
Start/Stop buttons
Reset button
Start forward
(programmable)
Start reverse
(programmable)
Start forward
Start reverse
(programmable)
(programmable)
Start/Stop
Reverse
Up
Down
3.1 Control
place
2.1.15 Jogging speed ref.
2.1.14 Fieldbus Ctrl reference
2.1.13 Keypad Ctrl reference
2.1.12 I/O B reference
2.1.11 I/O A reference
R3.2 Keypad reference
Motor
potentiometer
Programmable
Start/Stop and
reverse logic B
Programmable
Start/Stop and
reverse logic A
Internal
frequency ref.
Fig. 9: Control signal logic of the Local/Remote Control Application
3.4 LOCAL/REMOTE CONTROL APPLICATION - PARAMETER LISTS
3.4.1 MONITORING VALUES (CONTROL KEYPAD: MENU M1)
The monitoring values are the actual values of parameters and signals as well as statuses
and measurements. Monitoring values cannot be edited.
LOCAL/REMOTE CONTROL APPLICATION VACON · 45
24-HOUR SUPPORT +358 (0)201 212 575 · EMAIL: VACON@VACON.COM
3