Table 194: Selectable values for Actual Value Special Display
Value Unit On keypad
27 kW kW
28 Hp Hp
29 * Inch Inch
* = Valid only for Application 5 (PID Control Application).
NOTE!
The maximum number of characters that can be shown on keypad is 4. This means
that in some cases the display of the unit on the keypad does not comply with the
standards.
Fig. 89: Display example
A. Actual value min (max) B. Number of decimals
1080 DC-BRAKE CURRENT AT STOP 6 (2.4.14)
In the Multi-Purpose Control application, this parameter defines the current injected to the
motor in stop state when parameter ID416 is active. In all other applications this value is
fixed to a tenth of the DC brake current.
The parameter is available for NXP drives only.
1081 FOLLOWER REFERENCE SELECTION 6 (2.11.3)
Select the speed reference for the follower drive.
PARAMETER DESCRIPTIONS VACON · 353
24-HOUR SUPPORT +358 (0)201 212 575 · EMAIL: VACON@VACON.COM
8
To Next Page
Loading...
