Vacon NX series - Electro-Magnetic Compatibility (EMC); Using an RCD or an RCM Device

3.3 Control signal logic in Local/Remote Application 45
3.4 Local/Remote Control Application - Parameter lists 45
3.4.1 Monitoring values (Control keypad: Menu M1) 45
3.4.2 Basic parameters (Control keypad: Menu M2 -> G2.1) 47
3.4.3 Input signals (Control keypad: Menu M2 -> G2.2) 49
3.4.4 Output signals (Control keypad: Menu M2 -> G2.3 55
3.4.5 Drive control parameters (Control keypad: Menu M2 -> G2.4 59
3.4.6 Prohibit frequency parameters (Control keypad: Menu M2 -> G2.5) 60
3.4.7 Motor control parameters (Control keypad: Menu M2 -> G2.6) 61
3.4.8 Protections (Control keypad: Menu M2 -> G2.7 65
3.4.9 Autorestart parameters (Control keypad: Menu M2 -> G2.8) 67
3.4.10 Keypad control (Control keypad: Menu M3) 67
3.4.11 System menu (Control keypad: Menu M6) 68
3.4.12 Expander boards (Control keypad: Menu M7 68
4 Multi-step Speed Control Application 69
4.1 Introduction 69
4.2 Control I/O 70
4.3 Control signal logic in Multi-Step Speed Control Application 72
4.4 Multi-step Speed Control Application - Parameter lists 72
4.4.1 Monitoring values (Control keypad: Menu M1) 72
4.4.2 Basic parameters (Control keypad: Menu M2 -> G2.1) 74
4.4.3 Input signals (Control keypad: Menu M2 -> G2.2) 77
4.4.4 Output signals (Control keypad: Menu M2 -> G2.3 81
4.4.5 Drive control parameters (Control keypad: Menu M2 -> G2.4 85
4.4.6 Prohibit frequency parameters (Control keypad: Menu M2 -> G2.5) 86
4.4.7 Motor control parameters (Control keypad: Menu M2 -> G2.6) 87
4.4.8 Protections (Control keypad: Menu M2 -> G2.7) 91
4.4.9 Autorestart parameters (Control keypad: Menu M2 -> G2.8) 93
4.4.10 Keypad control (Control keypad: Menu M3) 93
4.4.11 System menu (Control keypad: Menu M6) 94
4.4.12 Expander boards (Control keypad: Menu M7 94
5 PID Control Application 95
5.1 Introduction 95
5.2 Control I/O 96
VACON · 8 TABLE OF CONTENTS
TEL. +358 (0)201 2121 · FAX +358 (0)201 212 205