2.5 LED indicator (non-display transmitter)
In the non-display transmitter model, the status of the transmitter and probe is indicated by
LED color and whether the LED blinks. When the transmitter is ON, one of the LEDs is always
illuminated (solid or blinking). If no LED is illuminated, the transmitter is OFF.
Table 3 LED indicator states
LED color and flashes Description
Green The transmitter, web UI, and probe are working normally.
Green, blinking The transmitter is starting up or no probe is connected to the
transmitter.
Red The transmitter is booting, and is not ready to receive measurement
data.
Red, blinking 4 times The probe has been disconnected.
Red, slowly blinking The transmitter is in error state.
2.6 Web interface
The transmitter also has a web interface for remote access. You can configure the web
interface to show numeric readings and graphs of 1 … 6 measurement parameters at the same
time. You can also configure the transmitter outputs and other transmitter settings, and
update the transmitter software.
The web interface has 2 user levels:
• Administrator: Configuration rights. Can configure outputs and change transmitter
settings.
• Guest: View-only access. Can add and remove measurement parameters in the
Measurements view.
The web interface supports most major browsers (for example, Firefox, Chrome, and Safari):
using the most recent version is recommended.
If you use the web interface with Firefox, make sure your device's time settings
are correct. Incorrect device time settings will prevent the use of the activation
code.
More information
‣
Web interface and main views (page 51)
‣
Starting up transmitter using web interface (page 61)
‣
Updating transmitter software version (page 97)
Indigo510, Indigo520 User Guide M212287EN-N
18
To Next Page
Loading...
