Figure 29 Date and time settings in web interface
The transmitter uses UTC (Coordinated Universal Time) internally. Time and time
stamps in the web interface are shown according to the time zone set in
Transmitter > Date and time.
1. Log in to the web interface as an administrator user.
2. Select Transmitter > Date and time.
3. To set date and time automatically:
a. In Set date and time, select Automatically.
b. Select Time zone.
c. In NTP server addresses, configure the Network Time Protocol (NTP) servers that the
transmitter will attempt to synchronize with.
NTP synchronization requires that the transmitter has a network
connection and the IP address of the NTP server is reachable.
Chapter 5 – Start-up
69
To Next Page
Loading...
