7.4.1 Testing relays in web interface
Figure 40 Relays test mode in web interface
1. Connect to the web interface.
2. Log in to the web interface as an administrator user.
3. Select Inputs and outputs > Relays.
4. In the Test mode tab, configure test mode settings.
a. In Test mode, turn the test mode on for the relay you want to test.
b. In Relay state, activate the relay.
5. Select Apply.
6. After verifying the output, go back to Inputs and outputs > Relays > Test mode and turn
the test mode o.
7. Repeat step 4…step 6 for all the relays you want to test.
Chapter 7 – Configuring transmitter using web interface
91
To Next Page
Loading...
