Figure 27 User creation page
The web interface has 2 user levels:
• Administrator: Configuration rights. Can configure outputs and change transmitter
settings.
• Guest: View-only access. Can add and remove measurement parameters in the
Measurements view.
1. In the User creation page, select Continue.
2. Type the activation code, and select Activate. Then select Next.
The activation code is printed on a label inside the transmitter enclosure. Use a 4-mm
Allen key to open the transmitter cover. A label with the activation code is also provided in
the accessory bag.
If you use the web interface with Firefox, make sure your device's time
settings are correct. Incorrect device time settings will prevent the use of the
activation code.
Indigo510, Indigo520 User Guide M212287EN-N
64
To Next Page
Loading...
