Vaisala Indigo500 Series - Updating Transmitter Software Version

• If you replace a probe with a new one that has the same measurement parameters as the
removed probe, the transmitter will continue to show those measurements once it detects
the new probe. Outputs will give an error notification, which will disappear when the new
probe is detected.
• If you replace a probe with a new one that has dierent measurement parameters as the
removed probe, you need to reconfigure the measurement parameters and outputs for
the new probe.
More information
‣
Connecting probes (page 44)
9.3 Updating transmitter software version
You can update the transmitter software through the web interface.
You need Administrator user rights for this task.
Before you start:
• Make sure that you have the software update file locally on your computer. You can
download the file from https://www.vaisala.com/en/lp/indigo500-software-download.
• If your transmitter does not have a network connection, make sure that both the
transmitter and the computer connected to it are set to use static network settings.
1. Connect to the web interface.
2. Log in to the web interface as an administrator user.
Chapter 9 – Maintenance and troubleshooting
97