Vaisala Indigo500 Series - Figure 16 Connecting Probes to Indigo500

When the probe connection cables have been wired to the transmitter, you can connect and
deconnect probes both when the transmitter power is on and when it is o. If the power is on
while you connect or deconnect a probe, the transmitter shows a notification about the probe.
If you have configured the transmitter to use outputs, the transmitter also notifies you of the
state of the outputs.
Connect only Vaisala Indigo-compatible probes to the transmitter.
3 4
1
2
5
Figure 16 Connecting probes to Indigo500
1
Probe connection cable, probe 1
2 Probe connection cable, probe 2 (dual-probe support in Indigo520)
3 Probe to be connected as probe 2 (GMP252 example)
4 Probe to be connected as probe 1 (HMP7 example)
5 The connector of the probe connection cable (5-pin M12)
You can connect the probes to the wall using the mounting accessory provided
with the probes.
More information
‣
Replacing probes (page 96)
Chapter 3 – Installation
45