Vaisala Indigo500 Series - Configuring Units in Web Interface; Finishing Start Up

4. To set date and time manually:
a. In Set date and time, select Manually.
b. Select Time zone, Date, and Time.
5. Select Apply.
More information
‣
Data logging (page 22)
‣
Configuring web interface home view (page 84)
‣
Configuring analog outputs in web interface (page 85)
‣
Configuring relays in web interface (page 89)
‣
Enabling Modbus TCP/IP in web interface (page 92)
5.2.8 Configuring units in web interface
You need Administrator user rights for this task.
Configuring units is a functionality introduced in software version 1.3.0. Defining custom units
is possible from software version 1.4.0 onward.
1. Log in to the web interface as an administrator user.
2. Select User > Preferences .
3. Select the unit type:
• Select Default metric units to use metric units in all measurement parameters.
• Select Default non-metric units to use non-metric units in all measurement
parameters.
• Select Custom units to define the units for the measurement parameters one-by-one.
4. To define the units for the measurement parameters one-by-one, select Transmitter >
Custom units.
Select the units from the drop-down lists for each parameter.
5. Select Apply.
5.2.9 Finishing start up
Follow these instructions only if you have connected to web interface with a
direct connection between transmitter and computer.
Indigo510, Indigo520 User Guide M212287EN-N
70