Installation Manual _________________________________________________________________
100 _________________________________________________________________ M210485EN-B
Mounting Present Weather Sensor
To install the Present Weather Sensor to the sensor arm that is
installed to the mast, follow the procedure below:
CAUTION
Do not touch the rain detector plate. Take special care to prevent it
from being hit. It is extremely fragile.
NOTE
Do not connect the power until the installation is completed.
1. Take the sensor from the shipping box.
2. Hold the sensor so that the hand screw is facing up, refer to
Figure 85 below.
3. When the hand screw faces the notch (number 1 in Figure 85
below), push the sensor in place and tighten the hand screw (2).
4. Secure the installation with an Allen screw on the opposite side
of the hand screw.
0306-045
Figure 85 Installing Present Weather Sensor
5. Attach the cable to the mast with the cable ties.
6. Connect the DC power/signal cable to the correct connector on
QMP202MP, see section Connecting Sensors to QMP202MP on
page 107.
To Next Page
Loading...
