Installation Manual _________________________________________________________________
84 __________________________________________________________________ M210485EN-B
Tilting the Mast
You need to tilt the mast, for example, when devices installed on the
upper assembly need to be aligned. The following sections provide
you with instructions on tilting the mast.
Disconnecting and Securing the
Guy Wire
1. Disconnect the guy wire 1 that is on the opposite side of the
mast to the hinge. For the location, see Figure 36 on page 52.
2. Connect the spring clip mounted to the released guy wire to the
hole in the hinge.
Using the Winch
1. Install the winch to the mast as instructed in section Installing
and Using the Winch on page 70.
2. Open the securing Allen bolts in the hinge.
CAUTION
Do not open the Allen bolts in the horizontal hinge axle.
3. Lower the mast slowly with the winch by turning the handle
counter clockwise.
CAUTION
Make sure to have a good grasp on the handle.
4. Install the tilting support to the end of the mast, see Figure 72 on
page 85.
5. Lower the mast slowly with the winch so that the mast finally
rests on the tilting support.
To Next Page
Loading...
