Vaisala MAWS201MP TACMET - Setting up the Radio Modems

Chapter 4 _________________________ Installation of the Weather Station Components to the Mast
VAISALA ______________________________________________________________________ 115
1. Setting up the radio modems.
- Entering owner information
- Setting channel frequencies
- Setting communications parameters
- Entering radio link settings.
2. Selecting the active channel.
Owner information, active channel, and channel frequencies are
mission dependent. For the rest of the settings, use the values
presented in Table 6 on page 118 and Figure 104 on page 117.
WARNING
Do not operate the radio modem near electrical blasting caps or in an
explosive atmosphere.
CAUTION
Improper setup of the radio modem may damage the unit.
CAUTION
Do not operate the radio modem unless all RF connectors are secure
and any open connectors are properly terminated.
NOTE
Before deployment, the radio modems must be configured.
Setting Up the Radio Modems
The radio modem settings are done with the PC/DOS software
RFMCONFD that is installed on the MIDAS IV PC. The program is
started in the TACMET Configuration Wizard window.