Installation Manual _________________________________________________________________
92 __________________________________________________________________ M210485EN-B
After installing other devices to the mast, connect the cables to the
QMP202MP unit as instructed in section Connecting the Cables on
page 106.
0306-040
Figure 77 Mounting the Bolt and Washer for Power Supply
Unit
Mounting the Obstruction Light
The obstruction light is installed to the holder that is installed between
the lightning rod holders. To install the obstruction light, follow the
procedure below:
1. Mount the obstruction light to the holder with two bolts (number
2 in Figure 78 on page 93).
2. Do not remove the paperboard cover (1) until you have
completed the entire installation procedure and you are ready to
erect the mast.
3. Route the cable (3) to the power supply unit and connect it to the
power supply unit as described in section Connecting the Cables
on page 106.
To Next Page
Loading...
