Installation Manual _________________________________________________________________
70 __________________________________________________________________ M210485EN-B
Erecting the Mast
NOTE
Before erecting the mast, refer to the installation instructions of the
additional sensors and devices. It is important to aim the sensors
correctly before erecting the mast.
Before erecting the mast, check that the bolts of the top fastener are
tight. The top fastener (number 1 in Figure 17 on page 30) is mounted
on the upper mast tube.
Installing and Using the Winch
It is always recommended to use the winch for erecting the mast. The
winch is easy to install and should be removed after use.
1. Attach the handle (number 5 in Figure 56 below) to the shaft of
the winch.
0310-057
Figure 56 Winch Installation
To Next Page
Loading...
