Installation Manual _________________________________________________________________
114 _________________________________________________________________ M210485EN-B
0310-063
Figure 101 UHF Antenna Mounted on the Mast
4. Check that the antenna is not over rain gauge (QMR101M) or
present weather detector (PWD11A) when the mast is erected.
5. Attach the cable (number 6 in Figure 99 on page 112 or in
Figure 101 above) to the mast with the cable ties.
6. Connect the cable to the correct connector on the radio, see
section Installing a Radio Modem to the Sensor Arm on page
120.
Configuring the Radio Modems
NOTE
This section applies only to the radio modem models TM32 and
RFM96W delivered by Vaisala.
Before installing a radio modem to the sensor arm or to the tripod, you
need to configure the radio modems. It is most convenient to
configure both radios in a row once you have stopped the MIDAS IV
software. The radio modem configuration consists of two steps:
To Next Page
Loading...
