Installation Manual _________________________________________________________________
132 _________________________________________________________________ M210485EN-B
Installing Optional Radio Communication
CAUTION
Only operate the radio modem with the antenna or appropriate
substitute (dummy load) connected.
NOTE
The radio modem in your system may differ from the one shown in
the figures of this section.
Follow the procedure below to set up and connect the radio modem to
MIDAS IV PC:
1. Before installing the radio modem to the tripod, select the same
channel as in the outdoors radio modem attached to the sensor
arm. Refer to section Selecting the Active Channel on page 119.
For the cable connections, refer to Figure 102 on page 116.
2. When you use a VHF antenna, you must use an antenna adapter
with the antenna tripod to attach the antenna to the tripod, see
Figure 113 below.
0011-049
Figure 113 VHF Antenna in Tripod
To Next Page
Loading...
