Chapter 4 _________________________ Installation of the Weather Station Components to the Mast
VAISALA ______________________________________________________________________ 111
Storing the Tools for Future Use
A tool bag is to be installed to the arm fixture of the logger tube. Store
all the provided tools in a tool bag , that is, key for the QMP202MP
enclosure, the Allen keys, screwdriver, and the adjustable wrench.
Connecting and Placing the Handheld Terminal
to the Logger Tube
Connect the handheld terminal cable to the Hand Terminal connector
on the upper base of the logger tube. The connector is marked with a
yellow arrow as shown in Figure 98 below. Place the handheld
terminal to the holder that is installed in front of the tool bag to the
arm fixture of the logger tube.
NOTE
To ensure faultless operation of the handheld terminal, you should
remove the handheld terminal from the holder and store it indoors in
the harsh weather conditions, for example, in cold climate.
0306-066
Figure 98 Connecting the Handheld Terminal
Installations inside QMP202MP
Normally all devices inside the QMP202MP unit are fully installed at
the factory, and there is no need to open the door of the enclosure.
To Next Page
Loading...
