Installation Manual _________________________________________________________________
76 __________________________________________________________________ M210485EN-B
2. Secure the guy wires with the provided wire rope clips (number
3 in Figure 64 below). Place the wire rope clips on the wire so
that the forged, grooved part clamps the wire coming from the
mast (the tension side) and the U-bolt clamps down on the end-
most section of the wire. Also check that the wire is properly in
the key groove (1).
3. After assembling the wire rope clips properly, strain the guy
wire by tightening the nuts (2) to slide the strap, until the initial
tension of the guy wires is sufficient. When tensioning the guy
wires, make sure that the mast remains straight and that all the
guy wires are equally tensed.
0207-092
Figure 64 Securing the Guy Wires
4. Cut the extra guy wire.
5. Finally, place the black and yellow cable shrouds around the guy
wires, see Figure 65 on page 77. There is one package of
shrouds for each wire.
To Next Page
Loading...
