Vaisala MAWS201MP TACMET - Figure 102 Connecting a Radio Modem to a PC for Configuration

Installation Manual _________________________________________________________________
116 _________________________________________________________________ M210485EN-B
1
2
3
0011-044
Figure 102 Connecting a Radio Modem to a PC for
Configuration
1. Disconnect the radio modem from outdoors, if already installed,
and place it near the MIDAS IV PC.
2. Shut all MIDAS IV programs on the MIDAS IV PC, and when
applicable disconnect the MIDAS IV PC from the QCA101 unit.
3. Connect the PC cable (number 2 in Figure 102 above) between
the PC and the radio modem, which has the data/power cable
(number 1 in Figure 102 above) connected.
NOTE
Do not connect the QMP211 power supply (number 3 in Figure 102
above) to the power supply connector at the PC end of the landline
cable (2), until the configuration software prompts you to supply
power to the radio modem.
4. Click the Radio Modem button in the TACMET
Configuration Wizard window to start the configuration
software.
5. Enlarge the appearing window by pressing ALT+ENTER.
6. Click the OK button.