Chapter 4 _________________________ Installation of the Weather Station Components to the Mast
VAISALA ______________________________________________________________________ 101
Mounting the Lightning Detector
To install the Lightning Detector to the sensor arm that is installed to
the mast, follow the procedure below:
1. Attach the sensor (number 1 in Figure 88 on page 102) to the
sensor arm (3) and tighten two bolts (2).
0306-046
Figure 86 Mounting Lightning Detector
2. Connect the DC power/signal cable to the connector on SA20M,
see Figure 87 on page 102 and the other end to the correct
connector on the QMP202MP unit, see section Connecting
Sensors to QMP202MP on page 107.
To Next Page
Loading...
