Installation Manual _________________________________________________________________
118 _________________________________________________________________ M210485EN-B
Table 6 Radio Modem Settings
Value Setting
Baud Rate 4800
Parity None
RS-485 Delay 0
Break to Command ON
Mode Packet Switched
EOT 5
Digipeater Delay 0.00
Local Node Non-Repeating
Link Rate 4800
Retries 3
CSMA Monitor ON
FEC ON
Scrambling ON
Digisquelch Moderate
TX ACK T/O 0.1
Local Addr 0
Dest. Addr 255
11. To specify channel frequencies, select Dealer - Customer
Configure, refer to Figure 105 below.
a. Under Diskette Type, select Channel Table Upgrade.
b. Add new frequencies.
c. Finally, click the OK button.
0306-062
Figure 105 Configuring Channel Frequencies
12. To save the information to the memory of the radio modem,
select Configure - Program.
13. After you have finalized the radio modem originating from
outdoors, connect the MIDAS IV PC to the radio modem
originating from indoors and start the procedure again from
step 3.
To Next Page
Loading...
