Installation Manual _________________________________________________________________
120 _________________________________________________________________ M210485EN-B
5. Follow the instructions on the screen to select the appropriate
COM port (usually COM1) and to connect the power supply
when asked to.
6. When the Model information window appears, click the OK
button to proceed.
7. To set the active channel, select Configure - Settings.
8. Under Channel Select, open the list of the channels by clicking
the green arrow. Refer to Figure 106 below.
0306-064
Figure 106 List of the Active Channels
9. From the list, double-click the desired channel to activate it.
10. Click the OK button.
11. To save the information to the memory of the radio modem,
select Configure - Program.
Installing a Radio Modem to the
Sensor Arm
Follow the procedure below to mount the radio modem to the sensor
arm and to connect the cables to a radio modem:
1. Install a radio modem (number 1 in Figure 107 on page 121) on
the sensor arm (3) that is equipped with an adapter (2). Just slide
the radio modem downward to the adapter.
To Next Page
Loading...
