Vaisala MAWS201MP TACMET - Figure 57 Securing the Clamp of the Winch; Figure 58 Lower Cable Lead

Chapter 3 ______________________________________________________ Installation of the Mast
VAISALA _______________________________________________________________________ 71
2. Install the winch towards the pedestal tube so that the tap (3) on
the tube goes to the hole (1) on the winch. Make sure that the
arrow on the winch faces up.
3. Wrap the clamps (2) around the tube to the clamp assemblies (4)
and attach them.
4. Finally, secure the clamps with the provided pin clips as shown
in Figure 57 below.
0310-058
Figure 57 Securing the Clamp of the Winch
5. Attach the cable bearer (number 4 in Figure 58 below) with the
shackle (2) to the plate lug (3) of the pedestal plate. Make sure
that the end of the wire (1) with the spring clip points east (when
installing in the northern hemisphere).
0310-059
Figure 58 Lower Cable Lead