Installation Manual _________________________________________________________________
72 __________________________________________________________________ M210485EN-B
6. Clip the spring clip (number 1 in Figure 59 below) to the plate
lug (2) of the lifting rod.
0310-060
Figure 59 Attaching the Spring Clip
7. Take a good grasp on the handle and turn it clockwise to erect
the mast. The winch is equipped with the friction break and thus,
it stops automatically when you release the handle.
WARNING
Make sure that there are no persons under the mast when the mast is
being erected.
WARNING
When erecting the mast with the winch avoid touching the wire with
your bare hands. Do not try to guide the wire.
WARNING
Always wear gloves when using the winch. Do not touch the gears of
the winch.
WARNING
Never leave the tilted mast resting on the winch, always use the
tilting support.
To Next Page
Loading...
