Chapter 3 ______________________________________________________ Installation of the Mast
VAISALA _______________________________________________________________________ 75
released when the mast is tilted. For the location of the guy
wires, refer to Figure 61 on page 74.
a. For the guy wires 2 and 3, connect the U-bolt (number 2 in
Figure 62 below) to the eye bolt (1) installed on the
concrete pad. Slide the strap (3) onto the U-bolt and thread
the nuts.
0207-091
Figure 62 Connecting the U-bolt to the Eye Bolt
b. For the guy wire 1, connect the U-bolt (number 3 in Figure
63 below) to the eye nut (1) with an additional bow
shackle (2) to enable easy releasing of the wire. The strap
(4) is used as with guy wires 2 and 3.
0303-047
Figure 63 Guy Wire 1 Attachment
NOTE
The additional bow shackle (number 2 in Figure 63 above) may differ
from the one shown in the figure.
To Next Page
Loading...
