Installation Manual _________________________________________________________________
80 __________________________________________________________________ M210485EN-B
0303-049
Figure 67 Ground Rod Installation
The following numbers refer to Figure 67 above:
1 = Access well
2 = Grounding rod
3 = Compression lug
4 = Grounding cable
Equipment Grounding
The equipment grounding cable is connected to the equipment ground
system (rod or other) from the one main grounding point, which is
normally a grounding bar located underneath the main system
enclosure.
CAUTION
Always use clamps for connecting a cable to the grounding rod or
two cables together, do not solder.
Consult the local authority for local grounding requirements. A copper
grounding cable and conductive grounding rod(s) are recommended.
Usually, the customer is responsible for supplying grounding cables,
rods, clamps, power cables, long distance signal cables, and conduits
for cables.
To Next Page
Loading...
