Installation Manual _________________________________________________________________
104 _________________________________________________________________ M210485EN-B
3. Align the ceilometer support north in the northern hemisphere
(south in the southern hemisphere) to ensure that the optical
window points away from the sun. To help the alignment, there
is an arrow on the support.
0306-050
Figure 90 Installing the Ceilometer Support
4. Open the delivery box of the ceilometer. Lift the ceilometer
using the handle of the unit and place it horizontally on the
delivery box.
5. Loosen and remove the Allen bolts attaching the mounting bars
on the support. Secure the mounting bars (number 1 in Figure 91
on page 105) to the legs of the ceilometer with the hand screws
(3).
6. Install two Allen bolts without any washers to the two holes
(number 4 in Figure 91 on page 105) nearest to the mast.
7. Place the ceilometer on the support arm so that the notches (2)
meet the Allen bolts installed to the holes (4) of the support.
8. Install two Allen bolts with the washers to the lower holes of the
support and tighten them properly.
9. Remove the Allen bolts installed in the holes nearest to the mast
and reinstall them with the washers and tighten them properly.
To Next Page
Loading...
