Installation Manual _________________________________________________________________
64 __________________________________________________________________ M210485EN-B
4. Thread the other Allen bolt to the axle and tighten both ends
with the Allen key.
Connecting the Lifting Rod to the
Mast
The delivery contains the lifting rod that is used with the winch to
erect and tilt the upper mast assembly. The clamps are preinstalled at
the factory to the lifting rod and to the lowest mast tube. The clamp on
the lifting rod has hooks (number 1 in Figure 49 below) and taps (2) to
ease the installation. The stainless steel bolts (3) are included in the
Lifting Rod Assembly Set (4).
0303-033
Figure 49 Lifting Rod Installation Accessories
To attach the lifting rod to the previously installed lower mast tube,
follow the procedure below:
1. Place the lifting rod (number 1 in Figure 50 on page 65) on the
mast assembly as shown in Figure 50 on page 65.
2. Make sure that both taps on the clamp go into the railing and the
hooks (number 3 in Figure 50 on page 65) at the end of the
clamp go firmly around the opposite clamp.
3. Install the bolts (number 2 in Figure 50 on page 65) with the
washers and tighten them with the Allen key.
To Next Page
Loading...
