Create a Message Give us your thoughts:
Ver-Mac 2016 V-Touch Controller User Manual, V3.0 16
6.3 Page Conditions
Page Conditions allow you put certain conditions to displaying a defined page. You can
adjust the appearance of each page of the message displayed on the sign board and
also define the conditions that cause a particular page of message to display.
If you message has more than one page, then you must set the page conditions
for each page separately.
A blank message page is a valid message and you must set Page Conditions
for it if you want nothing to display on the PCMS
6.3.1 Create a Message Triggered by a Radar Device
Figure 7 - Radar Trigger Page Conditions
When the radar device detects an approaching vehicle and its speed falls within a
pre-defined range, it triggers a targeted message to display on the signboard.
1. In Edit Message, create the message that you want to display when the
detected vehicle speed falls within your pre-defined limits.
2. Tap Radar and then Enable.
3. Set the Radar Conditions:
In the dialogue box, type or select to set the minimum and maximum of
speed that will cause the message to display.
Select either KM/H or MPH.
4. To attach your Page Conditions settings, tap Apply.
5. Tap any Operation buttons to save the message.
To Next Page
Loading...
