Vertical comdial DX-120 - Page 183

- 175 -
DX-120 Programming Manual PROGRAMMING FOR THE OPTIONAL T1 AND ISDN (T1/PRI) CARDS
Programming for the Translation Table via the DET (continued)
Setting the Day Service Mode:
From the DB Item Select screen (see steps 1 through 3 on page 173):
4) Enter 07-05-03 XXX-2 (where XXX represents the appropriate table row number: 001~ 001).
5) Press save to display the Day Destination screen.
6) Press chg.
7) Enter the number to which the Incoming digits are translated in Day Service Mode.
8) Press save to store the setting.
9) Press next to display the Alternate Destination screen (now go to step 6 in “Setting the Alternate Service
Mode:” below).
OR
Press the volume UP button to return to the DB Item Selection screen.
OR
Exit programming (see “Exiting Database Administration” on page 27).
Setting the Alternate Service Mode:
From the DB Item Select screen (see steps 1 through 3 on page 173):
4) Enter 07-05-03 XXX-3 (where XXX represents the appropriate table row number: 001~ 100).
5) Press save to display the Alternate Destination screen.
6) Press chg.
7) Enter the number you want the C.O. to use for the Alt Mode, as needed.
8) Press save to store the setting.
9) Press next to display Evening Destination screen (now go to step 6 in “Setting the Evening Service
Mode:” below).
OR
Press the volume UP button to return to the DB Item Selection screen.
OR
Exit programming (see “Exiting Database Administration” on page 27).
Programming for the Translation Table via the DET (continued on next page)