Chapter 3 Starting up
Fitting and removing a module
14 User Manual 79000000203 Rev. 005
Fitting and removing a module
Fitting a module
1 Turn the instrument face down on the work surface.
2 Set the two notches on the module part (1a) into the two holes
provided for that purpose on the Base (1b).
3 Make flush the 2 connections (2a & 2b), on module and base.
4 Once positioned, fix the module to the base screwing the 2 screws
(3a) fixing the receptacle.
The 2000 Platform must be switched off, and if it is
operating on the mains, its supply cable must be
unplugged.
To Next Page
Loading...
