Chapter 8 Stratasync
Configuring and synchronizing the 2000 Platform
User Manual 79000000203 Rev. 005 75
Pre-requisites for using the Stratasync with the 2000
Platform
The user must have subscribed to Stratasync, and by consequence, he
must have acquired an account Identifier and a password.
The Ethernet and Proxy parameters must have been correctly configured
in the System Settings page of the 2000 Platform (see “Ethernet > Mode”
on page 67 and “Proxy > Use proxy” on page 68).
Configuring and synchronizing the 2000
Platform
The 2000 Platform can be configured to be synchronized with the Strata-
sync.
1 Press Settings in the Home page
2 Check the configuration of the Ethernet and Proxy parameters.
3 Configure the Stratasync parameters:
a In the Server Type parameter, the Viavi Server is selected by
default and it is recommended to keep this parameter.
However, the user can select if necessary the Server Name
parameter and enter the name in the following parameter.
b In the Account ID parameter, enter the same identifier as the
one used to access to Stratasync.
c The Technician ID parameter is automatically fulfilled after
synchronization (if it has been defined by the administrator of
the Stratasync)
d To upload the files from a directory onto the 2000 Platform
toward Stratasync, select the parameter Upload from and press
right arrow key to enter the directory path (example: disk/
Stratasync). The directory Stratasync is defined by default.
To Next Page
Loading...
