Chapter 7 Transferring the 2000 Platform Interface
Establishing connection
User Manual 79000000203 Rev. 005 67
2 In the System Settings page, in the I/O Interfaces box, configure
the following parameters:
Remote Screen
Remote screen = Session or Permanent must be confirmed in both
cases, in the Interface E/S window.
No the screen cannot be remote on to a PC or on to
another 2000 Platform.
Session Mode the Remote screen function is inactive once the 2000
Platform is switched off.
Permanent Mode the Remote screen function is still active when the
2000 Platform is switched off and restarted.
Permanent with password
same function as the Permanent mode, with an
access to the equipment via VNC protected by a
password: 42000
The password to access VNC can be modified:
1 Click on the menu key Change password.
2 Enter the current password in the Edition keypad and press Enter to
validate.
3 Enter the new password and press Enter to validate.
Ethernet > Mode
Parameters of the local Ethernet network to which the 2000 Platform is
connected:
Config 1 to 4 static mode enabling input of the configuration of 4
sites. If this parameter is selected, the following
parameters must be entered:
– Site Name the user can enter the name of the site in the Edit menu.
To Next Page
Loading...
