Chapter 6 Scope
Launching a test of the connector and fiber end-face
User Manual 79000000203 Rev. 005 57
Launching a test of the connector and fiber
end-face
Launching a test of the connector and fiber
end-face
Once the display is correctly adjusted (magnification, sharpness...), a test
of fiber connector can be launched.
To launch the test:
1 Press Test key to launch the test of plugged fiber connector.
The test is completed:
– once the Led Testing is no more lit in red
– once the icon is no more displayed on the upper banner
– once a screen as the following one displays:
NOTE
To configure Pass/Fail criteria, see
"Configuring the Scope"
page 49
.
To Next Page
Loading...
