virtual access GW1000M Series - Page 174

23: Configuring mobile manager
_______________________________________________________________________________________________________
_____________________________________________________________________________________________________
© Virtual Access 2017
GW1000 Series User Manual
Issue: 1.9 Page 174 of 350
23.2.1 Basic settings
Web Field/UCI/Package Option
Description
Web: SMS Enable
UCI: mobile.main.sms
Opt: sms
Enables or disables SMS functionality.
0
Disabled.
1
Enabled.
Web: Collect ICCIDs
UCI: mobile.main.init_get_iccids
Opt: init_get_iccids
Enables or disables integrated circuit card identifier ICCID’s
collection functionality. If enabled then both SIM 1 and SIM 2
ICCIDs will be collected otherwise it will default to SIM 1. This
will be displayed under mobile stats.
0
Disabled.
1
Enabled.
Web: IMSI
UCI: mobile.main.imsi
Opt:imsi
Allows the IMSI (International Mobile Subscriber Identity) to be
changed
Default
Programmed in module
Digits
up to 15 digits
Web: PIN code for SIM1
UCI: mobile.main.sim1pin
Opt:sim1pin
Depending on the SIM card specify the pin code for SIM 1.
Blank
Range
Depends on the SIM provider.
Web: PIN code for SIM2
UCI: mobile.main.sim2pin
Opt:sim2pin
Depending on the SIM card specify the pin code for SIM 2.
Blank
Range
Depends on the SIM provider.
Web: HDR Auto User ID
UCI: mobile.main.hdr_userid
Opt:hdr_userid
AN-PPP user ID. Supported on Cellient (CDMA) modem only.
Blank
Range
Depends on the CDMA provider.
Web: HDR Auto User Password
UCI: mobile.main.hdr_password
Opt:hdr_password
AN-PPP password. Supported on Cellient (CDMA) modem only.
Blank
Range
Depends on the CDMA provider.
Web: n/a
UCI: mobile.main.disable_time
Opt: disable_time
Defines whether to use time obtained from the mobile carrier to
update the system clock when NTP is enabled.
0
Disabled.
1
Enabled.
Web: n/a
UCI: mobile.main.temp_poll_interval_sec
Opt: temp_poll_interval_sec
Defines the time in seconds to poll the mobile module for
temperature. Set to 0 to disable.
61
61 seconds
Range
Web: Name
UCI: mobile.@caller[0].name
Opt:name
Name assigned to the caller.
Blank
Range
No limit
Web: Number
UCI: mobile.@caller[0].number
Opt:number
Number of the caller allowed to SMS the router. Add in specific
caller numbers, or use the wildcard symbol.
Blank
Range
No limit
Characters
Global value (*) is accepted
International value (+) is accepted
Web: Enable
UCI: mobile.@caller[0].enabled
Opt:enabled
Enables or disables incoming caller ID.
0
Disabled.
1
Enabled.
Web: Respond
UCI: mobile.@caller[0].respond
Opt: respond
If checked, the router will return an SMS. Select Respond if you
want the router to reply.
0
Disabled.
1
Enabled.
Table 59: Information table for mobile manager basic settings