virtual access GW1000M Series - Page 195

25: Automatic operator selection
_______________________________________________________________________________________________________
_____________________________________________________________________________________________________
© Virtual Access 2017
GW1000 Series User Manual
Issue: 1.9 Page 195 of 350
Web: Health Monitor Interval
UCI: multiwan.[..x..].health_interval
Opt: health_interval
Sets the period to check the health status of the interface. The
Health Monitor interval will be used for:
interface state checks
ping interval
signal strength checks
Web: Health Monitor ICMP Host(s)
UCI: multiwan.[..x..].icmp_hosts
Opt: icmp_hosts
Specifies target IP address for ICMP packets.
Disable
Disables the option.
DNS servers
DNS IP addresses will be used.
WAN Gateway
Gateway IP address will be used.
custom
Ability to provide IP address.
Web: Health Monitor Conntrack Test
Host(s)
UCI: multiwan.wan.conntrack_hosts
Opt: conntrack_hosts
Conntrack is the feature used to track if there is any traffic to
and from an IP destination within the health interval.
Conntrack_hosts option defines the IP for conntrack to track –
usually the icmp_host IP is used.
If traffic to the conntrack_hosts IP is detected then multiwan
does not send a ping health check to the icmp_host otherwise a
ping is sent as normal to the icmp_host.
By default the conntrack_hosts is checked if the health interval is
greater than 5 minutes. This time threshold currently cannot be
manipulated.
Conntrack is generally used to limit the traffic sent on a GSM
network
Default
Conntrack checks for traffic from icmp_host IP
when health_interval is greater than 5 minutes
Disable
Conntrack disabled
Custom
Specifies an IP other than the icmp_host for
conntrack to track
Web: Health Monitor ICMP Timeout
UCI: multiwan.[..x..].timeout
Opt: timeout
Sets ping timeout in seconds. Choose the time in seconds that
the health monitor ICMP will timeout at.
3
Wait 3 seconds for ping reply
Range
Web: Health Monitor ICMP Interval
UCI: multiwan.wan.icmp_interval
Opt: icmp_interval
Defines the interval between multiple pings sent at each health
check
1
Range
Web: Health Monitor ICMP Count
UCI: multiwan.wan.icmp_count
Opt: icmp_count
Defines the number of pings to send at each health check.
1
Range
Web: Attempts Before WAN Failover
UCI: multiwan. [..x..].health_fail_retries
Opt: health_fail_retries
Sets the amount of health monitor retries before interface is
considered a failure.
3
Range
Web: Attempts Before WAN Recovery
UCI: multiwan.
[..x..].health_recovery_retries
Opt: health_recovery_retries
Sets the number of health monitor checks before the interface is
considered healthy. Only relevent if pre-empt mode is enbled.
5
Range
Web: Priority
UCI: multiwan.[..x..].priority
Opt: priority
Specifies the priority of the interface. The higher the value, the
higher the priority.
This multiwan interface priority must be higher than the one
specified in the priority field in the ‘Roaming Interface Template’
page described in the following section.
0
Range
Web: Exclusive Group
UCI: multiwan.[..x..].exclusive_group
Opt: exclusive_group
Defines the group to which the interface belongs, only one
interface can be active.
0
Range