virtual access GW1000M Series User Manual

25: Automatic operator selection
_______________________________________________________________________________________________________
_____________________________________________________________________________________________________
© Virtual Access 2017
GW1000 Series User Manual
Issue: 1.9 Page 201 of 350
Web: Attempts Before WAN Failover
UCI:
mobile.@roaming_template[1].health_fail
_retries
Opt: health_fail_retries
Defines the number of health check failures before interface is
disconnected.
3
Range
Web: Attempts Before WAN Recovery
UCI:
mobile.@roaming_template[0].health_rec
overy_retries
Opt: health_recovery_retries
Sets the number of health check passes before the interface is
considered healthy. This field is not used for a roaming template.
5
Range
Web: Priority
UCI:
mobile.@roaming_template[0].priority
Opt: priority
Type the priority number. The higher the value, the higher the
priority.
This multi-WAN interface priority must be lower than the one
specified in the priority field for the PMP interface.
0
Range
Web: Minimum ifup interval
UCI: multiwan.wan.ifup_retry_sec
Opt: ifup_retry_sec
Not used for a roaming interface.
300
Retry primary interface every 300 seconds
Range
Web: Interface Start Timeout
UCI:
mobile.@roaming_template[0].ifup_timeo
ut_sec
Opt: ifup_timeout
Specifies the time in seconds for interface to start up. If it is not
up after this period, it will be considered a fail.
40
40 seconds
Range
Web: Signal Threshold (dBm)
UCI:
mobile.@roaming_template[0].signal_thre
shold
Opt: signal_threshold
Specifies the minimum RSCP signal strength in dBm before
considering if the interface fails signal health check. Uses the
value stored for rscp_dbm in mobile diagnostics.
Range
-46 to -115 dBm
-115dBm
Table 68: Information table for roaming interface template
When you have configured your settings, click Save & Apply.
In the top menu, select System -> Reboot. The System page appears.
Figure 106: The reboot page
Check the Reboot now check box and then click Reboot.
25.2.4 Scenario 2: PMP + roaming: pre-empt disabled
As in the previous section, multi-WAN connects the PMP interface and uses auto created
interfaces for failover.

virtual access GW1000M Series Specifications

General

Brand	virtual access
Model	GW1000M Series
Category	Network Router
Language	English