virtual access GW1000M Series User Manual

25: Automatic operator selection
_______________________________________________________________________________________________________
_____________________________________________________________________________________________________
© Virtual Access 2017
GW1000 Series User Manual
Issue: 1.9 Page 207 of 350
Web: Minimum ifup interval
UCI:
mobile.@roaming_template[0].ifup_retry_
sec
Opt: ifup_retry_sec
Specifies the interval in seconds before retrying the primary
interface when pre-empt mode is enabled.
300
Retry primary interface every 300 seconds
Range
Web: Interface Start Timeout
UCI:
mobile.@roaming_template[0].ifup_timeo
ut_sec
Opt: ifup_timeout
Specifies the time in seconds for interface to start up. If it is not
up after this period, it will be considered a fail It is recommended
to configure a value greater than 120 seconds.
40
range
Web: Signal Threshold (dBm)
UCI:
mobile.@roaming_template[0].signal_thre
shold
Opt: signal_threshold
Specifies the minimum signal strength in dBm before considering
if the interface fails signal health check. Uses the value stored for
sig_dbm in mobile diagnostics.-115 dBm
Disabled
range
-46 to -115 dBm
Table 71: Information table for roaming interface template
When you have configured your settings, click Save & Apply.
25.2.7.1 Set multi-WAN operation
From the top menu, select Network -> Multi-Wan. The Multi-WAN page appears.
Figure 110: The multi-WAN page
In the Multi-WAN section click Add.
Web Field/UCI/Package Option
Description
Web: Enable
UCI: multiwan.config.enabled
Opt: enabled
Enables multiwan.
Select this option.
0
Disabled.
1
Enabled.
Web: Preempt
UCI: multiwan.config.preempt
Opt: pre-empt
Enables or disables pre-emption for multiwan. If enabled the
router will keep trying to connect to a higher priority interface
depending on timer set by ifup_retry_sec.
Leave this option unselected.
0
Disabled.
1
Enabled.
Web: Alternate Mode
UCI: multiwan.config.alt
Opt: alt
Enables or disables alternate mode for multiwan. If enabled the
router will use an alternate interface after reboot.
Leave this option unselected.
0
Disabled.
1
Enabled.
Table 72: Information table for multi-WAN operation

virtual access GW1000M Series Specifications

General

Brand	virtual access
Model	GW1000M Series
Category	Network Router
Language	English