virtual access GW1000M Series - Page 206

25: Automatic operator selection
_______________________________________________________________________________________________________
_____________________________________________________________________________________________________
© Virtual Access 2017
GW1000 Series User Manual
Issue: 1.9 Page 206 of 350
Web: Service Type
UCI:
mobile.@roaming_template[0].service
Opt: service
Specifies the service type that will be used to connect to the
network.
UMTS/GPRS
GSM module will automatically detect the
best available technology code.
Umts_only
Allows GSM module to only connect to 3G
network.
GPRS_only
Allows GSM module to only connect to GPRS
network.
cdma
Allows GSM module to only connect to cdma
network.
Web: APN
UCI: mobile.@roaming_template[0].apn
Opt: apn
APN name of Mobile Network Operator.
Web: PIN
UCI:
mobile.@roaming_template[0].pincode
Opt: pincode
SIM card’s PIN number.
Web: PAP/CHAP username
UCI:
mobile.@roaming_template[0].username
Opt: username
Username used to connect to APN.
Web: PAP/CHAP password
UCI:
mobile.@roaming_template[0].password
Opt: password
Password used to connect to APN.
Web: Health Monitor Interval
UCI:
mobile.@roaming_template[0].health_int
erval
Opt: health_interval
Sets the period to check the health status of the interface. The
Health Monitor interval will be used for:
interface state checks
ping interval
signal strength checks
Web: Health Monitor ICMP Host(s)
UCI:
mobile.@roaming_template[0].icmp_host
s
Opt: icmp_hosts
Specifies target IP address for ICMP packets.
Disable
Disables the option
DNS servers
DNS IP addresses will be used.
WAN gateway
Gateway IP address will be used.
custom
Ability to provide IP address.
Web: Health Monitor ICMP Timeout
UCI:
mobile.@roaming_template[0].timeout
Opt: timeout
Sets ping timeout in seconds. Choose the time in seconds that
the health monitor ICMP will timeout at.
3
Wait 3 seconds for ping reply
Range
Web: Attempts Before WAN Failover
UCI:
mobile.@roaming_template[1].health_fail
_retries
Opt: health_fail_retries
Defines the number of health check failures before interface is
disconnected.
3
range
Web: Attempts Before WAN Recovery
UCI:
mobile.@roaming_template[0].health_rec
overy_retries
Opt: health_recovery_retries
Sets the number of health check passes before the interface is
considered healthy. This field is not used for a roaming template.
Web: Priority
UCI:
mobile.@roaming_template[0].priority
Opt: priority
Type the priority number. The higher the value, the higher the
priority.
0
range