virtual access GW1000M Series - Page 267

28: Configuring SNMP
_______________________________________________________________________________________________________
_____________________________________________________________________________________________________
© Virtual Access 2017
GW1000 Series User Manual
Issue: 1.9 Page 267 of 350
Web Field/UCI/Package Option
Description
Web: Security Name
UCI: snmpd.com2sec[x].secname
Opt: secname
Specifies an arbitrary security name for the user.
Web: Source
UCI: snmpd.com2sec[x].source
Opt: source
A hostname, localhost or a subnet specified as a.b.c.d/mask or
a.b.c.d/bits or 'default' for no restrictions.
Web: Community
UCI: snmpd.com2sec[x].community
Opt: community
Specifies the community string being presented in the request.
Table 91: Information table for Com2Sec settings
28.2.3 Group settings
Group settings assign community names and SNMP protocols to groups.
Figure 135: The group settings section
Web Field/UCI/Package Option
Description
Web: Group
UCI: snmpd.group[x].group
Opt: group
Specifies an arbitrary group name.
Web: Version
UCI: snmpd.group[x].version
Opt: version
Specifies the SNMP version number being used in the request:
v1, v2c and usm are supported.
v1
SNMP v1
v2v
SNMP v2
usm
SNMP v3
any
Any SNMP version
Web: Security Name
UCI: snmpd.group[x].secname
Opt: secname
An already defined security name that is being included in this
group.
Table 92: Information table for group settings