To Next Page

To Previous Page

31: Configuring Terminal Server

_______________________________________________________________________________________________________

_____________________________________________________________________________________________________

GW1000 Series User Manual

Issue: 1.9 Page 301 of 350

31.6.3 Terminal Server debug statistics

To see debug statistics about the terminal server, enter:

root@VA_router:~# tserv show debug all

TERMINAL 1, Dev: /dev/ttySC0

State: LISTENING

netRxBuf length=0 offset=0 hdrsz=0

ttyRxBuf length=0 offset=16 hdrsz=16

line_status_mask = 0x0 line_status = 0x0

RFC2217 negotiated=0

Tcp tx last error: 0

31.6.4 Terminal Server advanced debugging

To see advanced debug commands for the terminal server, enter:

root@VA_router:~# tserv

=== Termserv disgnostics. Command syntax: ===

tserv show stats - show statistics

tserv clear stats - clear statistics

tserv show serial - show serial interface status

tserv send serial0 <data>- send data to serial port 0

tserv start capture N, N=port number (0 to 3) - start capturing rx serial

data

tserv print capture N, N=port number (0 to 3) - print captured rx serial

data

tserv show serial txlog-hex <Port> [length], Port=port cfg index (0 to 3),

length=length to show

tserv show serial rxlog-hex <Port> [length], Port=port cfg index (0 to 3),

length=length to show

tserv show serial txlog-asc <Port> [length], Port=port cfg index (0 to 3),

length=length to show

tserv show serial rxlog-asc <Port> [length], Port=port cfg index (0 to 3),

length=length to show

tserv show debug - show debug info

tserv show userial stats - show USB serial card statistics

tserv clear userial stats - clear USB serial card statistics

tserv start userial rxlog - start USB serial card rx log

tserv show userial rxlog <offs> <length> - show USB serial card rx log

virtual access GW1000M Series User Manual

Other manuals for virtual access GW1000M Series