virtual access GW1000M Series - Page 326

35: Event system
_______________________________________________________________________________________________________
_____________________________________________________________________________________________________
© Virtual Access 2017
GW1000 Series User Manual
Issue: 1.9 Page 326 of 350
option tls_forcessl3 '0'
option timeout_sec "10"
option from x@example.com
option to y@example.com
option subject_template "%{severityName} %{eventName}!!!"
option body_template "%{eventName} (%{class}.%{subclass}) happened!"
35.7.7.8 Option conn_tester ‘pinger’email target table options
UCI/Package Option
Description
UCI: va_eventd.<target
label>.name
Opt: name
Name of the target to be used in the forwarding section.
UCI: va_eventd.<target
label>.enabled
Opt: enabled
Enable this target.
0
Disabled.
1
Enabled.
UCI: va_eventd.<target
label>.type
Opt: type
Must be 'email' for a syslog target.
syslog
Syslog target.
email
Email target.
snmptrap
SNMP target.
exec
Exec target.
UCI: va_eventd.<target
label>.smpt_addr
Opt: smtp_addr
IP address or FQDNand port of the SMTP server to use. Format:
x.x.x.x:port or fqdn:port
UCI: va_eventd.<target
label>.smtp_user
Opt: smtp_user
Username for smtp authentication.
UCI: va_eventd.<target
label>.smtp_password
Opt: smtp_password
Password for smtp authentication.
UCI: va_eventd.<target
label>.use_tls
Opt: use_tis
Enable TLS (Transport Layer Security) support.
0
Disabled.
1
Enabled.
UCI: va_eventd.<target
label>.tls_starttls
Opt: tis_starttis
Enable StartTLS support.
0
Disabled.
1
Enabled.
UCI: va_eventd.<target
label>.tls_forcessl3
Opt: tis_forcessl3
Force SSLv3 for TLS.
0
Disabled.
1
Enabled.
UCI: va_eventd.<target
label>.timeout_sec
Opt: timeout_sec
Email send timeout in seconds.
10
10 seconds
Range
UCI: va_eventd.<target
label>.from
Opt: from
Source email address.
UCI: va_eventd.<target label>.to
Opt: to
Destination email address.
UCI: va_eventd.<target
label>.subject_template
Opt: subject_template
Template to use for the email subject.