virtual access GW1000M Series - Page 325

35: Event system
_______________________________________________________________________________________________________
_____________________________________________________________________________________________________
© Virtual Access 2017
GW1000 Series User Manual
Issue: 1.9 Page 325 of 350
UCI: va_eventd.<target
label>.conn_tester
Opt: conn_tester
Name of the connection tester to use for this target.
UCI: va_eventd.<target label>.
snmp_version
Opt: snmp_version
Ability to change snmp version
1
Version1
2c
Version 2c
3
Version 3
Table 117: Information table for syslog target settings
35.7.7.5 Email target
When an email target receives an event, it sends it to the configured email address.
35.7.7.6 Email target using UCI
va_eventd.@target[0]=target
va_eventd.@target[0].name=email1
va_eventd.@target[0].enabled=1
va_eventd.@target[0].type=email
va_eventd.@target[0].smtp_addr=smtp.site.com:587
va_eventd.@target[0].smtp_user=john_smith@site.com
va_eventd.@target[0].smtp_password=secret word
va_eventd.@target[0].use_tls=0
va_eventd.@target[0].tls_starttls=0
va_eventd.@target[0].tls_forcessl3=0
va_eventd.@target[0].timeout_sec=10
va_eventd.@target[0].from=x@example.com
va_eventd.@target[0].to=y@example.com
va_eventd.@target[0].subject_template=%{severityName} %{eventName}!!!
va_eventd.@target[0].body_template=%{eventName} (%{class}.%{subclass})
happened!
va_eventd.@target[0].conn_tester=pinger
35.7.7.7 Email target using package options
config target
option name email1
option enabled 1
option type email
option smtp_addr "smtp.site.com:587"
option smtp_user 'john_smith@site.com'
option smtp_password 'secret word'
option use_tls '0'
option tls_starttls '0'