virtual access GW1000M Series - Page 344

36: Configuring SLA reporting on Monitor
_______________________________________________________________________________________________________
_____________________________________________________________________________________________________
© Virtual Access 2017
GW1000 Series User Manual
Issue: 1.9 Page 344 of 350
monitor.main.monitor_ip=10.1.83.36
monitor.v2=keepalive
monitor.v2.enable=yes
monitor.v2.interval_min=1
monitor.v2.monitor_ip=172.16.250.100
monitor.v2.dev_reference=TEST
monitor.v2.snmp_version=2c
monitor.v3=keepalive
monitor.v3.enable=yes
monitor.v3.interval_min=1
monitor.v3.monitor_ip=172.16.250.100
monitor.v3.dev_reference=TEST
monitor.v3.snmp_version=3
monitor.v3.snmp_uname=TEST
monitor.v3.snmp_auth_pass=vasecret
monitor.v3.snmp_auth_proto=MD5
monitor.v3.snmp_priv_pass=vasecret
monitor.v3.snmp_priv_proto=DES
root@VA_router:~# uci export monitor
package 'monitor'
config keepalive 'main'
option enable 'yes'
option interval_min '1'
option dev_reference 'mydevice'
option enabled 'yes'
list monitor_ip '10.1.83.36'
config keepalive 'v2'
option enable 'yes'
option interval_min '1'
list monitor_ip '172.16.250.100'
option dev_reference 'TEST'
option snmp_version '2c'
config keepalive 'v3'
option enable 'yes'
option interval_min '1'