Chapter 6, Using Vitals Mobile-HC (HC-100 Controller): Vitals Mobile Controller Operation
E.H. Wachs Part No. 79-MAN-04, Rev. I 105
If you get a Transducer Error
message during operation,
there is something wrong
with the transducers or
cables. Operating with faulty
transducer readings could
cause valve damage. See
“Transducer Errors” at the
end of this section.
9.
Press START to begin the valve operation. The valve
exerciser will run in the selected mode. The button
will turn red and the text will change to
STOP.
10.
To turn the valve exerciser slightly in either direction
(for positioning or installing the valve key), tap and
hold on the
Jog LH or Jog RH button. The operator will
turn as long as you keep touching either of these but-
tons.
See Appendix A for a
description of the operating
modes.
11.
By default, the valve exerciser mode is EXER, which
runs the valve exercising protocol. You can also oper-
ate in Emergency Mode (
EMER) and Manual Mode
(
MAN). Tap the Mode button to switch modes.
12.
Press STOP to end the valve operation. The button will
blink white and green and the text will change to
START.
13.
To reset the valve operation readings and the operat-
ing defaults, tap and hold the
Reset button.
14.
The status line shows details of the currently active
connection or operation. You can tap the status line to
toggle through current status messages, including
operating values, connection messages, and exercising
status messages.
15.
If the status line is a string of numbers, it is displaying
the current connection type and machine selection.
• turn count
• transducer 1 value
• transducer 2 value
• machine ID
• machine status.
CAUTION
NOTE
To Next Page
Loading...