Vitals Reference Manual
196 Part No. 79-MAN-04, Rev. I E.H. Wachs
Soft Reset
1. Try soft resetting the device by pressing and holding the
Power (On/Off) key for 5-10 seconds until the Power
Button menu appears. Tap Reset.
Restoring to Factory State (Clean Boot)
CAUTION: Restoring the HC-100 to its original factory
state permanently erases data saved on the handheld, any
software you installed, and any changes you made to the
handheld, including changes to settings.
1. Back up files and programs you want to keep onto
another computer.
2. Save open files and close running programs on the
handheld. Press and hold the power button until the
Power Button menu appears. Tap
3. Reset.
4. When the screen turns black, press and hold the power
button again. The BIOS screen is shown.
5. Move the top slider on the screen to the right to set or
clear factory defaults. This clean boots the handheld.
6. Tap Exit. The boot process continues.
Symptom: Touchscreen not accurate or responding to
touch input
Touchscreen performance can be optimized for individual
situation or whether using a finger vs. stylus input.
Adjust Touchscreen Settings
1. Settings>System>Touch
2. Select Touch Profile (Stylus 10 is the recommended
default profile).
3. Finger and Stylus profiles available.
To Next Page
Loading...