3-68 BA 901/1101 en – Edition 2.1 * 91101b340.fm
Operation
Further recommendations for digging
When planning and performing digging work, we recommend that you observe the
following points:
• Exits from pits must be outside the digging line and as level as possible
• Dig by removing adjacent strips if possible
• Ensure that you can perform forward machine travel when driving out of the digging
area with a fully loaded bucket
• Whenever possible, perform reverse machine travel when transporting a full bucket
down a steep slope
Loading vehicles
When loading vehicles, we recommend taking the following into account:
• If possible, the truck and the working direction of the bucket should form an angle of 45°
• Only raise the full bucket to the tilt-out height when you are driving in a straight line
toward the truck
• If possible tilt out with the wind behind you to keep the dust away from your eyes, air
filters and fans
Freeing the machine
If your machine gets stuck in the ground:
☞ Tilt out the bucket until the blade is vertical above the ground
☞ Lower the loader unit all the way
☞ Gradually tilt in the bucket
➥ The machine is pushed backward
☞ Reverse slowly
☞ Repeat this procedure until the wheels reach firm ground
☞ Reverse the machine away
To Next Page
Loading...
Need help?
General
